next up previous contents
Next: Kdblur Up: Convolution Model Components Previous: Gsmooth

ireflect: reflection from ionized material

Convolution model for reflection from ionized material according to the method of Magdziarz & Zdziarski (1995, MNRAS, 273, 837). This is a generalization of the pexriv and bexriv models. Ionization and opacities of the reflecting medium is computed as in the absori model. The reflection component alone can be obtained for . Then the actual reflection normalization is |relrefl|. Note that you need to change then the limits of  excluding zero (as then the direct component appears). If , there is no cutoff in the power law. The metal and iron abundance are variable with respect to those set by the command abund.

When using this model it is essential to extend the energy range over which the model is calculated both on the high and low end. The high end extension is required because photons at higher energies are Compton down-scattered into the target energy range. The low energy extension may be required to calculate ionization fractions correctly. The energy range can be extended using the extend command. The upper limit on the energies should be set above that for which the  input spectrum has significant flux. To speed up the model, calculation of the output spectrum can be limited to energies below a given value by using xset to define IREFLECT_MAX_E (in units of keV). For instance, suppose that the original data extends up to 100 keV. To accurately determine the reflection it may be necessary to extend the energy range up to 500 keV. Now to avoid calculating the output spectrum between 100 and 500 keV use the command xset IREFLECT_MAX_E 100.0.

  The core of this model is a Greens' function integration with one numerical integral performed for each model energy. The numerical integration is done using an adaptive method which continues until a given estimated fractional precision is reached. The precision can be changed by setting IREFLECT_PRECISION eg xset IREFLECT_PRECISION 0.05. The default precision is 0.01 (ie 1%).

par1

reflection scaling factor (1 for isotropic source above disk)

par2 = z

redshift

par3

abundance of elements heavier than He relative to the solar abundances

par4

iron abundance relative to the above

par5

cos i, the inclination angle

par8

disk temperature in K

par9

disk ionization parameter, , where Fion is the 5eV – 20keV irradiating flux, n is the density of the reflector; see Done et al., 1992, ApJ, 395, 275.

 

next up previous contents
Next: Kdblur Up: Convolution Model Components Previous: Gsmooth